MIL-PRF-2819H
2.2.2 Other Government documents, drawings, and publications. The following other Government documents,
drawings, and publications form a part of this document to the extent specified herein. Unless otherwise specified,
the issues of these documents are those cited in the solicitation or contract.
NAVAL SEA SYSTEMS COMMAND (NAVSEA) PUBLICATIONS
Nuclear Powered Submarine Atmosphere Control Manual, Chapter "Material
S9510-AB-ATM-010
-
Control Program"
(Copies of the chapter titled "Material Control Program" are available from Commander, Naval Sea Systems
Command, ATTN: SEA 05Z4, 1333 Isaac Hull Ave. SE Stop 5122, Washington Navy Yard, DC 20376-5122.)
2.3 Non-Government publications. The following documents form a part of this document to the extent
specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or
contract.
ASTM INTERNATIONAL
ASTM C165
-
Standard Test Method for Measuring Compressive Properties of Thermal Insulations
ASTM C177
-
Standard Test Method for Steady-State Heat Flux Measurements and Thermal
Transmission Properties by Means of the Guarded-Hot-Plate Apparatus
ASTM C203
-
Standard Test Methods for Breaking Load and Flexural Properties of Block-Type
Thermal Insulation
ASTM C303
-
Standard Test Method for Dimensions and Density of Preformed Block and Board-
Type Thermal Insulation
ASTM C356
-
Standard Test Method for Linear Shrinkage of Preformed High-Temperature Thermal
Insulation Subjected to Soaking Heat
ASTM C411
-
Standard Test Method for Hot-Surface Performance of High-Temperature Thermal
Insulation
ASTM C421
-
Standard Test Method for Tumbling Friability of Preformed Block-Type and
Preformed Pipe-Covering-Type Thermal Insulation
ASTM C449
-
Standard Specification for Mineral Fiber Hydraulic-Setting Thermal Insulating and
Finishing Cement
ASTM C518
-
Standard Test Method for Steady-State Heat Flux Measurements and Thermal
Transmission Properties by means of the Heat Flow Meter Apparatus
(Copies of these documents are available from ASTM International, 100 Barr Harbor Dr., P.O. Box C700, West
Conshohocken, PA 19428-2959 or online at www.astm.org.)
International Organization for Standardization (ISO)
ISO/IEC 17025
-
General Requirements for the Competence of Testing and Calibration Laboratories
(Copies of this document are available from International Organization for Standardization (ISO), 1, ch. de la Voie-
Creuse, Case postale 56 CH-1211 Geneva 20, Switzerland or online at www.iso.org.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between
the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this
document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Qualification. The insulation block furnished under this specification shall be products that are authorized
by the qualifying activity for listing on the applicable qualified products list before contract award (see 4.2 and 6.3).
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business